Qidi Tech Hanging Raspberry Pi and Camera Mount

thingiverse

I am using OctoPrint to drive my Qidi Tech I printer and wanted a way to mount my Raspberry Pi and Raspberry Pi camera (v1.3) to the printer. I searched and found a lot of great cases and solutions but none of them quite fit the Qidi Tech and relied on additional materials. This solution hangs on the left handle - the RPi is exposed on the outside and the camera faces the bed through the glass - both are pressure fit with tight tolerances. The text says OctoPrint and is included as a separate .stl for dual extrusion or optionally including. If I revisit I would probably make a more universal design to allow for mounting on either side or flipping the RPi to better route the USB and camera cables. I am a novice at design so I welcome any feedback and/or advice on improvements but it fits securely and so far I am very happy with the solution. Print Settings Printer: Qidi Tech I Rafts: No Supports: Yes Resolution: 0.2mm Infill: 30% Notes: It took a few hours to print - print in supplied orientation (upside down - i.e. hanger on bed plate). I used ABS (slight warping as seen in pics) with a couple of extra perimeters and while it could be stronger, I'm not sure that it really needs to be. How I Designed This Designed in Sketchup Collected measurements w/ Digital Caliper Leveraged RPi specifications from here: http://www.raspberrypi-spy.co.uk/wp-content/uploads/2014/07/raspberry_pi_model_b_plus_dimentions.png Leveraged RPi Camera specifications from here: http://www.recantha.co.uk/blog/wp-content/uploads/2013/05/Raspberry-Pi-Camera-Module-Diagram-853x10242.png