qq-s pro direct drive ( BondTech LGX Lite Large Gears Extruder & Phaetus Rapido Hotend )

cults3d

To do... make an casing for the level sensor so it fits over the custom air duct. 2022-05-30 Made inserts to guide the bowden tube so it stays in the center. You can use an allen key on the center inserts. 2022-05-28 Fixed the M10 hole, Used the wrong thread... fixed that. 2022-05-25 Added a tool plate with a M10 hole so you can use a bowden setup. In case you don't have the Bondtech extruder... yet ;-) Made some small changes to the "air duct" 2022-05-25 Change the top part. Made it easy to quickly remove the "hot-end & extruder" part for easy nozzle swapping. Added a first "fan tunnel" design that requires not screws to mount. It is made up of 2 parts that prints easy without any support. 2022-04-23 Added first test version. I have not done any real live tests so far. Use M2.5 screws. 25mm for the fans. For the bottom part ( effector plate ) 1 screw 10 to 12mm for the "middle" hole and the other 2 holes 10mm... MAX 10mm! For the "mount lock" 2x 12mm. Pre drill the holes with a 2mm drill. And use a 10mm screw to on al holes before you put it al together. Do not over tighten... Your "plastic" will get damaged if you over tighten it. You also need to make sure that some "surfaces" are smooth for a 100% level setup for the hot-end. Look at the images in the zip file. 2022-04-18 Convert your Bowden setup to an direct drive setup using the "BondTech LGX Lite Large Gears Extruder" and "Phaetus Rapido Hotend" Design. This is under development so nothing usable to download at the moment. You can use this to keep track if your interested. The "stl" is a preview of the hole setup in one object so you can already see the whole setup.