Quad Lock phone case for DJI OM 4

thingiverse

My Quadlock case is way to big for the clip DJI Supplies, and the locking buldge means no glue on magnet. So i made an adaptor to allow a glued magnet connect with the quad lock correctly and not cuase balance issues. Tried to make a quad lock adaptor that just sat into the case clip, but that was always too far out and caused balance issues so this was the easiest solution, works a treat and is pretty strong so i doubt it will break during use. Made the quad lock a bit more solid connecton, first few turns may be a bit hard but needed to keep it secure. make sure you keep the magnets protusion in line with one of the four quad lock triangle angles, otherwise your camera will be at a 45 degree angle.