Quest 2 DAS Adaptor Alternate Design (Franken Quest)

thingiverse

Inspired by the other DAS adaptors but not a remix. My goal was to make a new version of the adaptor that has minimal support material by eliminating the middle layer. Print it with the flat side down and you should only need support under the very back edge. The ends of the strap and headset lay against each other but there are notches inside the adaptor that both firmly click into. I didn't make a Top Buckle adaptor, so you'll want to find one you like from another project (I used the top buckle from https://www.thingiverse.com/thing:4626882 on mine). I did the main modelling in Sketchup and touched it up on blender. I might have gone a little too low poly and the side walls are a bit thin.