Quest 2 Simple Koss KSC75 Mounts

thingiverse

NOTE - MUST MIRROR PART IN SLICER FOR PROPER LEFT/ RIGHT! These are simple KSC75 mounts I made for the Quest 2. I use them with the stock headband, but they *might* work with the elite headband or others. Pop off the ear clips the drivers came with, and carefully put these on. If tight or hard to go on, I recommend carefully prying the snap channel open with a tiny screwdriver while trying to insert them. You can then grip the channel again to close it up a bit with needle nose pliers. Yes, they rattle a bit when the headset if off your head, but should stay still once on your head, and adjust themselves flush against your ears. They are made to be held on by THIN 1/2" wide velcro strip such as this. They will need to be trimmed to length, and possibly width if too snug in the slot. https://www.amazon.com/VELCRO-Brand-Reusable-Fastening-Organizing/dp/B000F5K82A/ref=sr_1_27?dchild=1&keywords=1%2F2+velcro+roll&qid=1622544801&sr=8-27 NOTE - MUST MIRROR PART IN SLICER FOR PROPER LEFT/ RIGHT!