Quick Box Fang for Stock CR-10 for 40mm Blower fan

thingiverse

This is a quick little design which I haven't tested yet. I designed it to slide right onto the existing stock CR-10 hotend metal shroud. Just remove the stock filament side fan (keep the screws), add a JST connector, add your 40mm x 40mm x 20mm Blower fan, remove the two shroud mount screws, slide on this quick box fang, use the x4 side fan screws you kept to mount the box fang to your shroud, mount the shroud the the hotend mount plate with those same two screws. Done! Let me know how best to print this. Because the walls are thin... 3mm max to 1mm min... to keep mass low... it will be hard to print.. and especially a pain in the but if you use any support which would get into the wind chambers. As it would be a pain to remove from in there. Tolerances are also tight. But... should work! But let me know please. Thank you. Licensing bs: My release of this design is licensed with a modified Creative Commons attribution non-commercial license with a modification that allows me the right to revoke the license at any time from individuals or companies which I deem are abusing the license. If you wish to use this design commercially for whatever reason, you may contact me to inquire about commercial license via my LinkedIn profile or twitter. Those profile links are below. https://twitter.com/DavidAELevy https://www.linkedin.com/in/davidaelevy/ Enjoy! And happy printing!