Quick change paper roll holder

cults3d

This model of scroller with its quick change system, fun to use, fast to print and nice to assemble. Will make you want to change the rolls more regularly and with pleasure. The assembly system is simple. Initially, start with the thread because the first time it is a little hard, we will "wake up" a little, for this, take a wrench or pliers. Start to screw by hand until you can no longer, using the wrench or pliers, screw a half turn then loosen and so on until the end of the thread. Remove the screw completely, insert the "pivot", then screw again leaving the "pivot" free, it must be able to move without jamming. For the installation of the set it is also very simple. You just have to fix to the wall the file named "Clips" (you will need 2) and then clip on the "left and right supports". (See GIF) The distance between 2 "Clips" is : - 255 / 260 mm for paper towel roll - 130 /135 mm for toilet paper roll Its fastening means is hidden and is only visible / accessible from below. In order to unclip the support of its "Clips", this provide a flat screwdriver, insert in the slot and lift upwards, push the screwdriver to the bottom and then lift upwards....until the part comes out ( see GIF ). Good PRINT