quick release camera mount base, which can be attached to 1/4 inch photo screw

prusaprinters

<p>I had an existing quick release mount from my normal camera tripod. But i needed a quick release base on my small desk tripod for usage of a dslr as webcam.</p> <p>With the print i can attache the existing camera mount (ground is round about 4.4cm x 4.4cm) plate on the quick release which is screwed on the 1/4 inch photo screw of the small, desk tripod.</p> <p>The system do not use any screws on its own. You can print free of support.</p> <p>Attention: Once the hinge is closed, it should hold the mount tight enough to prevent the camera from wobbling. Test the system for stability before attaching a camera on your own.</p> <h3>Print instructions</h3><p>Print</p> <ul> <li>0.2mm layer height</li> <li>0.4 or 0.6mm nozzle</li> <li>no support</li> <li>15% infill</li> </ul> <p>Assembly</p> <ul> <li>place the printed plate on a desk and screw the photo tripot in the hole for the photo screw (on first assembly this should be a little harder).</li> <li>add the hinge inside the large hole</li> <li>!test if it hold tight enough to hold you camera!</li> </ul>