Quickdraw Stick Clip

thingiverse

Reinforced and improved stick clip uploaded by climbryn. I modeled the leg to be much stronger and tweaked the head clip for a better hold and flex, as well as created a second head file for more flexible filaments (the nylon head file is thicker on the plates that hold the gate open, as I experimented with taulman 230 and 910 filaments). I have a reusable velcro strap to attach it to a stick, but a cable tie would work just as well. I would advise printing in the orientation the image of the print shows -this leaves the layers in a better orientation making the whole print significantly stronger. Problems I had with previous versions were the end of the leg was easy to snap off when the draw was attached, if the clip was dropped or stick bumped out of the way. I also found wire gate draws were difficult to properly secure. If you have any issues with this one, leave a comment and I can see about addressing them. I'm working on a better design (pictured, green) but I'm still perfecting the details to make it stronger/better. I hope to have it up soon!