R/C 1:10 Car Stand for Yokomo with integrated motor cooler.

thingiverse

This thing was made for a Yokomo R/C chassis. Feel free to stretch the width for the needs of your car. The integrated fan (40x40mm type) blows fresh air to the motor and cools it down. A small micro switch starts the fan when the car chassis it placed on the stand. It is easier to print the thing in three parts and glue them together. Note: The fan inlet on the base part is closed because I need that as support structure. It is very thin and can be broke out after printing. This thing was made with Tinkercad. Instructions It is easier to print the thing in three parts and glue them together. The fan inlet on the base part is closed because I need that as support structure. It is very thin and can be broke out after printing. You can use a standard 40x40mm fan. On the fan left side is a little electronic box. Place the fan cable to this box and connect it with the micro switch. You can close the box with a little cover or fill it with hot glue or something else. On the bottom side are 4 holes to place some foam.