R.O.B. Gyro

thingiverse

R.O.B. parts are relatively expensive in this current period. So I have created the first reproduction Gyro designed for use with R.O.B. theoretically, it should work just fine, however, the Gyro MAY be to light to be used with the spinner. I uploaded a second version in which you can glue M8 washers to add extra weight to the Gyro. Version 1 is the first variation that does not use any extra weights. Version 4 (2 and 3 didn't quite work out) uses washers in the center for extra weight so it will work with the Gyro Spinner as version 1 was too light. The two variations of the pt2 are practically the same, except version 2 uses more of a edge blend on the top. Both versions are available in case the edge blend causes problems. To build one, you will need the following: 1 m3 screw that is at around 35mm long. 2 washers that have a 50mm diameter and a 14mm inner hole diameter. It also has to be approximately 1mm thick. A quick note, I would recommend printing at 100% infill to add the extra weight. if version 1 doesn't work with your spinner, print the heavier version 4. Another note, don't screw the m3 in all the way, otherwise it will not spin correctly.