R Sphere Puzzle

thingiverse

Customized version of http://www.thingiverse.com/thing:642211 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=642211 Instructions Using the following options: - Set connector neck gap to 0.3 mm. - Choose latitude steps equal to 3 times more than the standard number of options. - Activate the south connector by setting its switch to ON position. - Specify longitude steps in sets of five distinct categories. - Adjust the quality rating for connectors up to 30 levels higher than normal. - Determine the index point at which to place latitude lines. - Set the sphere radius equal to sixty times larger than average. - Configure west connectors with settings that cancel each other out. - Design font styles from write/Letters.dxf files only. - Multiply connector sizes by a factor of 0.06 units. - Type text as uppercase letter 'R'. - Define a specific scale for text measurements at 1 to 1 to 1 ratio. - Configure pole connectors north and south in a symmetrical array with identical settings. - Establish gaps between each piece in the design layout. - Choose an average thickness of pieces in millimeters equal to ten times more than standard options. - Set the offset of text to absolute coordinates [0,0]. - Enable pole connectors on the northern side with settings that are opposites of normal values. - Prioritize quality settings for sphere rendering at one hundred percent maximum level.