R106 5G CPE shell

thingiverse

This is a 3D printed case for R106. Has both active and passive cooling mode. And you can also swap the antennas if you like. To build this ,you need: Four M2*14 screws Two M2*6 screws Six M2 nuts Three 28*28*3mm heat sinks One 3007 turbine One SS-12F15 G5 switch Three 5cm welded to SMA female (note that the line should be selected with a wire diameter of 1.13 ） Three 10cm welded to SMA female (note that the line should be selected with a wire diameter of 1.13 ） (Pay attention to the inner pin or inner hole of SMA, I personally choose the female inner hole and the inner pin antenna) (Actually, you can also choose to use six 10cm welded to SMA, that would made the cable management process a lot easier)