Race Car

prusaprinters

<p>A race car that'll fit a hot-wheels track. Overall dimensions are at scale of a typical car of this type. Movable wheels with a <code>0.3mm</code> gap that most printers can handle.</p><p><strong>Version 4</strong> has the wheels lowered (body raised) by <code>1mm</code> and front wing reinforced. I would suggest this version over v3.</p><h3>Print instructions</h3><p>Included is a wheel axles mesh that you should use to print with an infill of 100%. This is necessary to make the 3d print strong enough to take lots of abuse without breaking.</p><p>&nbsp;</p><p>After printing if you want to get the wheels to roll well, use some sand paper on a flat surface and sand the bumps from 3d printing down, (roll the car back and forth at a 45 degree angle so the wheels get sanded but still spin)</p>