Radenso DS1/Theia mag mount

thingiverse

Windshield permanent and GoPro mag mounts for Radenso DS1 and Theia (and Uniden R7). Replaces the single suction cup piece of the supplied mount. Pick a mount and back from the "A" parts Pick a clip part from the "B" parts Pick a radar detector base part from the "C" parts Other hardware needed: 3/4" x 1/2" x 1/8" N52 neodymium magnets (the mount is designed to hold 2 magnets) such as https://www.ebay.com/itm/151891775798?var=452970698050 2 sided tape such as 3m VHB tape or GoPro mounting hardware such as a GoPro blendmount. #4-40 3/8" flat head screws (1/4" might be better, I needed to cut the length of a couple) https://www.ebay.com/itm/112015601109?var=410954292051 #4-40 nuts Some dense foam to put between the magnets and back. I used some sticky pads used to put on chair/table legs that I got at the dollar store that are 4mm thick. The connectors I used are from Mill-Max: 868-22-004-00-011101 for the connector with the pins 868-10-004-00-012000 for the mating connector with concave face or 868-10-004-00-011000 for the mating connector with flat face Some rectangular pieces of steel 1.3mm thick, I used a joist hanger from Lowe's and used a dremel tool to cut pieces out of it. https://www.lowes.com/pd/Simpson-Strong-Tie-2-x-6-Concealed-Flange-Hanger/3034124 A countersink tool is handy for countersinking the screws into the steel plates: https://www.harborfreight.com/countersink-and-deburring-tool-set-3-pc-61629.html