Radeon RMS mount for the Red Sea Max Nano

thingiverse

A mount that allows the Radeon RMS mounts to be attached to the Red Sea Max Nano tank. It replaces the original switch box which will have to be relocated if you are still using it. The hole for the bolt is undersized so it can be tapped with either a commercial M8 tap or by screwing the bolt that comes with the RMS into the print. Print 2 of the screws that locate into the tank. In my case they were printed at 100% fill for extra strength. Update: The file RMS_mount_V1.stl has been added. This file allows for the nano control box to be retained and moved to the left. Update2: I have been informed of one case where the printed screws snapped unfortunately ending up with the light in the tank. The screws were printed at a low infill rather than 100% but to ensure this cannot happen again i have uploaded reinforced_screw.stl. This screw takes an M5 25mm screw, either cap or hex head though the centre to a captive M5 nut. Use a reasonable size washer under the screw head and it will prevent the screw from snapping in this way.