Radio Tower Simple

prusaprinters

<h4>Fun Radio Tower for Outer Space Play!&nbsp;</h4><p>Original design for the <a href="https://print.thelmshow.com/pages/2022-lm-show-christmas-community-print-drive">2022 Christmas Community Print Drive</a>.</p><p>Also available: <a href="https://www.printables.com/model/313561-radio-tower-toy">Radio Tower with Dishes</a> Shown in group photo.<br><i>Version with open legs will be published after the print drive.</i></p><p><strong>More Models: </strong><a href="https://www.printables.com/social/158303-loyal-moses/collections/318891"><strong>Collection of all approved 2022 Christmas Community Print Drive models</strong></a></p><h3>Additional Information and Print Settings</h3><p>Model is approximately 50 x 53 x 150 mm. I printed with 0.2 mm layer height, 3 perimeters, 12% infill, and 4 top and bottom layers (*see note below). No supports. No raft.</p><figure class="table"><table><tbody><tr><td>If you are printing for the <strong>Community Print Drive</strong>, be sure to use the appropriate guidelines:<br><a href="https://print.thelmshow.com/pages/2022-christmas-community-print-drive-guidelines">https://print.thelmshow.com/pages/2022-christmas-community-print-drive-guidelines</a></td></tr></tbody></table></figure><h4>Also See my Four Planets</h4><p>These planets were also designed for the 2022 Christmas Community Print Drive.</p><ul><li><a href="https://www.printables.com/model/312026-planet-with-craters">Planet with Craters</a></li><li><a href="https://www.printables.com/model/312073-planet-with-ring">Planet with Ring</a></li><li><a href="https://www.printables.com/model/312075-planet-with-stripes">Planet with Stripes</a></li><li><a href="https://www.printables.com/model/312068-planet-smooth">Planet Smooth</a></li></ul><h4>More of my designs on Cults3D: <a href="https://cults3d.com/en/users/abbymath">https://cults3d.com/en/users/abbymath</a></h4><p><i>Not for commercial use. No derivatives. See license below.</i></p><p>*Note: Depending on the slicer, it may print faster if some regions have bottom and/or top layers removed. If you like playing with slicer settings, here is what I did: Bottom and top layers are removed after height 1 mm. However, this created a tiny gap at the top of the leg arches and the bottom of the side decoration, so I put them back between 35.5 and 44 mm. Top layers included again at 147.5 mm through to the end height.</p>