Rail Mount System and Raspberry Pi Mount- Qidi / Flashforge

thingiverse

This is a rail-mount system for pretty much anything you want to mount to the top rear left of the Qidi Tech 1 (FlashForge Creator Pro Clone). The rail is custom designed, and you should be able to just attach it to any STL you have. The base mount is quite a bit longer than necessary (see photo above), but again, you can easily cut that to length using your favorite STL editor (TInkerCad is super simple for this). I have also attached a separate STL file for a remix I did of Adafruit's Raspberry Pi 3 w/ 3.5" TFT screen case. I had some problems printing it with the mount attached, so I cut them into two parts and ended up welding them together using my 3D pen. Print Settings Printer: Qidi Tech 1 Rafts: No Supports: Yes Resolution: 0.2mm Infill: 20% Notes: Print the mount upside down with supports under the press-fit corner connector. The rail needs to be attached to another model, so it depends on how your other model prints best. Your tolerances need to be reasonably precise for the rail mount, especially on the bottom layer, however you can always sand that if necessary.