Railcore LGX Mount using mosquito

myminifactory

This is a mount for the Bondtech LGX with a mosquito attached for the Railcore. It is intended to use the 713Maker Railcore II ZL series ultralight Y plate to mount to. I've included the .step files if you need to modify anything. Before attaching the mount plate, attach the Y endstop placing 2x M2 nuts into the mount nut captures.Next, use 2x M2x10mm screws and put them through the endstop and tighten them into the nuts in the mount (be careful not to overtighten and strip the nut capture) Be sure the wires are lower down on the mount so you do not smash them between the LGX and the mount. Use 2x M3 Heatset inserts and place them into the bl-touch holes using a soldering iron. I use www.amazon.com/gp/product/B07NBTCHP1 Use 5x M3x8mm screws to attach the mount to the aluminum mount plate (1 screw hole will be blocked by the endstop wires) Place the Bondtech LGX into the mount and use 4x M3x6 screws to mount it. Attach the BL-touch using 2x M3x6 screws Use 2x M3 Heatset inserts into the LGX fan mount. attach it to the aluminum mount plate using 2x M3x8 screws. This is placed on the back side of the aluminum mount plate rather than the front. Attach the James Toungue LGX fan to the fan mount using 2x M3x6 screws. Finish wiring and you're done! BL-Touch offsets are:dY = 23.39dX = -7.13