Ramps-pi-Display modular case

thingiverse

I found several of the other cases ether didn't support all the following: Pi Arduino Ramps board Full Display or they were just to crowded, hard to mount the boards, and hard to wire up. Many of the designs also required a bit of supports. Every side of this case is removable. It set up to print every piece without supports.It isn't that hard to assemble, but there are a lot of screws that are required. Feel free to tweak the design as needed. The foot is scaled for a US 8/32 nut (sorry all you metric lovers out there, It is what I had on hand)