raspberry Case TinkerCAD

thingiverse

The original looks like a great case. Only had a few issues that were corrected: One half was NOT normalized (it was floating above the print surface) FIXED No indents for the case closures to latch the case closed ADDED. Was only provided combined and too big for some printers- needed to be separate to print on smaller printers. FIXED. Needed to be a little stronger - too easy to break. FIXED Needed a break-out spot for a GPIO cable if used. ADDED All files are consistent now. And I think I finally have it appropriately cleaned up, strengthened and printable after 4/25/14 rev!! This thing was made with Tinkercad. Edit it online https://tinkercad.com/things/e3YECt67i29 Instructions Print the two separate files- they have been run through nettfab to clean the files up.. Does not need support- use it if you want.