Raspberry house for AM8

thingiverse

Thanks to CPT_Spekkie and Adinin for their help with feedback. I've added the .f3d file for those willing to make personal changes. If you create something and share it on Thingiverse, please write my name as the original author. Please always read version reports and use the appropriate versions. This case was made for a Raspberry 3 for AM8. It provides access to audio, HDMI, power, and SD card, as well as GPIO against the extruded frame. There is also a cable duct for use between the rasp and electronic case. Here's what you'll need: * 1 pc thumbscrew M4 (self-tap) * 3 pc M5 screws 10mm (4 pc if you decide to use the duct) * 4 pc 2.5mm screws and nuts Keep in mind that the screws for the side of the frame may require a smaller screw size since the GPIO ports may be in the way. This issue should be fixed in V5. I printed this case with supports, and my rasp fit perfectly after I went over the contact holes quickly with a knife to smooth out the edges. This will remain a work-in-progress until someone else prints it and gives it an "ok." 2017-06-19 Version fix: In V4, I made significant fitting adjustments, including making the holes larger for fastening to the frame and coning the holes for rasp screws so they don't collapse during print. 2017-06-20 V5: Added more space to the power jack for those using phone charger cables. V6: Forgot to remove a small part when I extruded the case. Lid V3 updated to fit V6. I created a cable hider for use between the electronic case and the raspberry. The network cable goes inside the housing and out on the back through a small hole. I haven't tested this yet. There's also a cable house for those using corners from the AM8 project, which is 4cm to be placed between the rasp and electronic case.