Raspberry Pi 2 Exoskeleton

thingiverse

Inspired by http://www.thingiverse.com/thing:374377 by SOUNDSK His design was modified to fit the Raspberry Pi model 2/3 and provide more mounting options. Assembly can use 4x #2 screws or 4x M3x10 cap head screws to hold the two halves together. Lots of other pass holes ( some with hex nut recesses ) to allow more bracketry or mounting. The pc board is "pinched" between the upper and lower components. The assembly and the two halves supplied in Designspark format (.rsdoc). This will allow you to modify any hole sizes or wall thicknesses to work better on your printer. RaspberryPi2 model derived from step file included in :https://grabcad.com/library/raspberry-pi-2-model-b-3d-cad-assembly-model-2 created by Robèrt Akòpov Print Settings Printer: Hadron ord bot Rafts: No Supports: Doesn't Matter Resolution: 0.35mm nozzle, 0.2mm layer Infill: 15% Notes: No support needed but some of the screw holes and nut tramps have internal transition layer when lower diameter is larger than upper hole. 3 perimeters and 15% infill looked good on my printer. use netfabb to section out a corner to tune in the design before you print the entire thing. (see rpi-exo-bot_sample2.stl) top : filament used = 2983.0mm (19.2cm3) bottom : filament used = 2255.9mm (14.5cm3)