Raspberry Pi 3 and Arducam mount for Ender 3 - No extra hardware needed

thingiverse

This is a Raspberry Pi 3 + Camera mount for the ender 3. I didn't find any that fit my requirements so I made one. + Most parts prints with no support, and where it's needed support is minimal. + No extra hardware to fit and mount the parts. + No extra hardware to mount the RPI. Just slide it into place and go. + Designed around the inexpensive Arducam, the pi & camera mount accommodates the short 6" ribbon cable it comes with, eliminating the need to buy a replacement. + The camera mount uses ball Joints that are printed horizontally. They require no support, and if you have good bed adhesion no brim either. + Horizontally printed ball joints are stronger and less prone to breaking than vertically printed ones, allowing for tighter tolerances and a more snug fit. + The camera mounts to a 2020 v-slot by way of a twist mount, you can mount it just about anywhere. + All parts were printed and test fit before submitting to thingiverse I've included the source files, made in Wings3D for anyone that wants to tinker with the design.