Raspberry Pi 3 Case with Homematic RPI-RF-MOD

prusaprinters

<p>This is an easy to print case for the Raspberry Pi 3B+ and the Homematic RPI-RF-MOD<br/> It's for the Pi 3(B+) only and won't work with the Pi 4 - for the Raspberry Pi 4 based case <a href="https://www.thingiverse.com/thing:4215608">click here</a>.<br/> You need 3x M2.5x6mm screws</p> <p>After the print, remove the integrated supports in the HDMI and Micro-USB Ports with a sharp knife.<br/> Then insert the RPi and fix it with 2 screws to the bottom.<br/> Install the RPI-RF-MOD and close the case with the top. insert the last M2.5x6mm screw into the square hole and secure it.<br/> One hole at the top of the case shows the Status LED (bigger one) and the other is to press the reset button with a needle or similar small and thin piece.<br/> I highly recommend to use small rubber bumpers (like 3M bumpon) with a diameter from 7-9mm on the bottom part to keep some distance to the wall/surface and not covering the venting holes.</p> <p>I designed a clickable insert for this square hole so you can make your own "stickers" on it. (or use the raspberry in the example). For this please use the Nupsi.step as a start.</p> <p>Parts to print:</p> <ul> <li>1x Bottom.stl<br/> OR</li> <li>1x Bottom_mounting-holes.stl</li> </ul> <ul> <li>1x Top.stl<br/> OR</li> <li><p>1x Top_vent.stl optional:</p> </li> <li><p>Logo_example.stl<br/> or any of your own designs using the Nupsi.step as mounting base [UPDATE 09/MAR/2020]:</p> </li> <li><p>Added bottom part for wall mounting using 2x 3.5-4mm screws [UPDATE 11/MAR/2020]:</p> </li> <li><p>Added an optional top with venting holes [UPDATE 14/MAR/2020]:</p> </li> <li><p>slight adjustments for easier RPi installation</p> </li> </ul> Category: Household