Raspberry Pi 3 Hybrid Slim Case

thingiverse

This is a case for Raspberry Pi 3. Thanks to leave a LIKE. Even a little Tip is highly appreciated. Since i am fascinated from the small size of the raspberry pi, I wanted to keep the case as small as possible. Furthermore I wanted to ensure accessibility of the GPIO´s, the flat cable connections and all of the ports. In addition I wanted to have various mounting options. You have a flat bottom surface so that you can simply use double sided tape. You have mounting holes in the bottom so that the case can be screwed. And on top you have "Quick mounting" devices. Once the "quick mounting devices" are screwed, you can install and remove the raspberry pi easily without using any tools. You can use them... but you don´t have to. For designing the Case I used a 3D Model of the raspberry itself so the case actually fits very well. please note: Since each printer has its own tolerances and therefore the print quality might vary from machine to machine - you can slightly rework the print with some sandpaper at the following sections: the 4 Push pins: The fit should be tight. But in case you need too much forces to push the top into the bottom (danger of destruction) please slightly rework with sandpaper. the wall mounts: The fit should be tight. But in case you need too much forces to push the case into the wall mounts please slightly rework with sandpaper. Print recommendation: I recommend high infill percentage. (>80%). Layer Height = 0.1mm to 0.15mm Supports are not required. Cherz Print Settings Printer: Wanhao Duplicator i3 Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: 0.1 to 0.15 Infill: 80%