Raspberry Pi 3B/+ case

prusaprinters

<p>This is a case for the Raspberry Pi that I designed just because I wanted to see if I could. I needed something to hold my Pis with PoE HATs, which could let the heatsinks work but also had decent airflow if I pointed a fan at them.</p><p>I just used random screws I had lying around, but if you need specifics, the screws holding the Pis are 2.5mm, and the ones for the lid are old case screws from various old PCs. The ‘feet’ were standoffs for an old hard drive cage, but any thumb screw that is longer than the bit of the heat sink that sticks out the bottom should work.</p><p>This was designed with the LoveRPi PoE HATs in mind, so it may be a bit short for the official HAT.</p>