Raspberry Pi 4 B Case with Display + Camera Slot and 40mm Fan

thingiverse

Based on the model by Robee Shepherd https://www.prusaprinters.org/prints/36017-raspberry-pi-4-b-case-with-camera-slot-and-fan-oct/ **Notable features:** * Accessible GPIO Pins * 40mm Fan support * Slots for Display and Camera cable **Changes from the original:** * Cutout in the top half to access the GPIO Pins * Added slot for display cable * Changed spacing for the fan to fit a 40mm fan with M3 screws * Replaced vertical vent slots on the side with horizontal ones * Reduced internal structures like standoff / slots for easier printing * Reduced thickness of top and bottom from 3.5 to 1.5 mm The horizontal vents are 30x1mm cutouts each. Printed fine with PLA without supports The Raspberry Pi 4B fits very snug into the case. You may want to snap off the Standoff Pins in the case for the Mounting holes of the Pi depending on the accuracy of your print