Raspberry Pi 4 Case for OctoPrint

thingiverse

This is a Raspberry Pi 4 case that is intended to attach to any Creality printer or other printer designed with aluminum rails. The bottom half of the case has two slots for the anchor to slide into so that you can orient the Raspberry Pi 4 case on your printer as you choose. The fit between the case bottom and case anchor is a little tight to make sure that the case stays where it is mounted. There are ventilation holes on the top half of the case above the hottest IC's. There is an access slot to easily access the GPIO of the Raspberry Pi 4. Naturally, there's also access in the top of the case to pass through a camera ribbon cable.