Raspberry Pi 4 Case Remix 40mm Fan + Camera Cable Slot

thingiverse

Remixed from: https://www.thingiverse.com/thing:3717401 I mainly remixed the top of the case to allow a 40x40x10mm 5V Noctua fan to be mounted on it using some self cutting screws (I think they come with the fan). Also, I added the slot for a camera cable as in other remixes (like this one: https://www.thingiverse.com/thing:4601571) I power the fan via 3,3V to reduce noise, even a Noctua fan gets loud at some point. There is still a little bit clearance between the fan and the heatsink on the processor, this might cause problems with higher heatsinks. I also modified the stand since I wanted to print it without the support and the stand itself was only attached as an .obj file in the original post. Many thanks to the original poster: https://www.thingiverse.com/tipam/designs This Pi 4 case is probably the best one I have printed so far (and I went through quite a lot already), especially the stand design is really cool!