Raspberry Pi 4 Top - Screwless FAN Mount (30/40mm Noctua)

prusaprinters

<p>This is a remix of the great Raspberry Pi Case Top of <a href="https://www.thingiverse.com/Malolo"> Malolo</a>. We've had a good cooperation over the last few days and have worked on the design and new ideas to make the case even better.</p> <p>So the idea to integrate a fan without the ugly screws.<br/> I've therefore built a holder in which the fan can be simply pushed from the side.</p> <hr/> <p><strong>Please note:</strong></p> <p><strong>30mm</strong><br/> The 30mm fan height is limited to 7,5-8mm. Works great with Pi-FAN.<br/> Unfortunately, the GPIO socket connector are a bit too high for the low case and therefore have to be modified. Pull the GPIO pin out of the connector and it fits perfectly.</p> <p><strong>40mm</strong><br/> The 40mm fan height is 12mm and optimized for Noctua NF-A4x10 5V.<br/> For the connection to GPIO socket you can use the orignal Noctua molex connection. You just have to swap the cable ends.<br/> The 4010 fan height is 10mm and for all others standard fans.</p> <hr/> <p><strong>Upades:</strong></p> <ul> <li>added a higher version (thanks to Malolo) for 40mm Noctua NF-A4x10 5V with bigger air slots and repositioned horizontal slots at the back</li> <li>added a version for 4010 fans with 10mm height.</li> </ul> <hr/> <p>Let me know what I can improve or what wish you have.<br/> Looking forward to your makes :)</p>