Raspberry Pi 7 inch LCD stand, Now with Tabs!

prusaprinters

<p>Wanted to use this stand until I received a bamboo one I ordered, but I didn't have screws. I added tabs in front of the screw holes that go underneath the raised holes on the screen. Also added a small lip at the bottom to support the screen (not the glass). The screen will fit either right-side-up or upside-down but works better upside-down. (Designed that way due to power to the Pi)</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>LulzBot</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>TAZ 6</p></div><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div><strong>Resolution:</strong></p> <p>.18</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>20%</p></div></p> <p><strong>Notes:</strong></p> <p>Supports would be helpful, depending on your filament. I had them turned on, but Cura didn't make them all, for some reason. Still turned out ok in PLA with fans on</p> </p></p></p> Category: Electronics