Raspberry Pi 7" Tablet

thingiverse

The base of this design in really cool to me. I feel it to be a nice base for adjustment. There is a lot of room to add other things. It still has a nice form factor and sits well on a table or in a lap. If anything I just wanted to make it easier to adjust and open up all the ports. I took the .STL files and imported into SketchUp. It took me a few hours to clean up the extraneous line created from the import. Then it was just a bit of trial and error. I will include the source files when I feel it is done. The yellow header will be gone at that time. ;) New Parts: Button: https://www.adafruit.com/products/917 Speaker: http://amzn.to/2hgUjhd Heatsink : https://www.adafruit.com/products/3082 2x - Adafruit Power Boost 1000c: https://www.adafruit.com/products/2465 2x - Lithium Ion Polymer Battery - 3.7v 4400mAh: https://www.adafruit.com/products/354 Screws: 2x - M2.5 x .45 x 6M 6x - M3 x .5 x 6M 8x - M3 x .5 x 10M Changes: Lid has was made taller. This gives a lip around the screen. In case of a fall, the edge of the case should take the impact. Lid was given a cutout to accommodate the ribbon cables for the inset edge made in #1. All ports made accessible. Moved raspberry pi towards the wall to line up ports closer to the outside edge. Shift card slot to match new raspberry pi location Removed switch hole Made a big hole to accommodate the switch listed in "New Parts" Filled gaps above usb and HDMI ports. Adjusted sizes of all port holes. Adjusted holes in the brackets so the case can use a standard screw. (Details Pending) Adjusted size of side of bracket to accommodate new pi position. Added two power boost and batteries due to constant voltage issues with only one.