Raspberry Pi B+ / 2 / 3 / 3B+ Acryl (3mm) Vesa Mount (100x100mm)

thingiverse

Mount your RPi B+, RPi 2, RPi 3 or RPi 3B+ on the back of your monitor with this 100mm vesa mount! I made this design from scratch to get a little more space on my workplace and to get rid of all the cables laying around that are connected to my Raspberry Pi 2 and because I use my RPi 2 more as a mediacenter. The 1.2 version is plain and for monitors that dont get too hot on the backside. The 1.3 version got hexagons all over the plate for some better airflow between the mount and RPi. (My HP monitor gets pretty hot especially in summer) Also the hexagons make the mount a little bit lighter but it`s stable at the same time. Use two standoff rings or the long spacers (in the additional vectorfile) per M4 bolt, between the vesa mount and monitor. Use some zipties and the small parts to secure all cables down to the mount to prevent possible demage on your RPi connectors. You will figure it out just by taking a look at the pictures. The additional vectorfile contains long spacers for the M4 bolts and for the RPi. I was quickly annoyed that I dropped the round spacers so often that I designed those. WHAT YOU WILL NEED: 3mm acrylicglass (At least 150x124mm) 4x M4x20 bolts (lenght depends on your monitor) 4x M4 washers 4x M2,5x10 bolts (If you don`t use a case for your RPi) 4x M2,5 washers 3x zipties NOTICE: !The CAD-files are made for Lasercutters! I did use a Trotec Speedy 100 (60W CO²-Tube).