Raspberry Pi Box for Volumio, 5 inch display

cults3d

This is an enclosure for a Raspberry PI and a 5 inch display. The opening in the back allow for the addition of a Hifiberry Digi+ (pro). This is a perfect box for a Volumio audio streamer. The display I used is this one (not affiliated):https://osoyoo.store/products/osoyoo-5-inch-dsi-touch-screen-lcd-display-800x480-with-ips-screen-material?variant=31738826686575 The design was inspired by https://www.thingiverse.com/thing:4570624. But I wanted something smaller and easier to print. I provide two versions of cover: with and without opening for the Raspberry USB/Ethernet connector on the side. For a wifi Volumio streamer, I prefer the cover without the side opening. I provided the source code of the design (openscad). You can customize it to your liking. Specifically useful if you want to use different size of screw. The current design requires the following screw and heat insert: - For Raspberry PI: M2.5 heat insert, 4x - For Raspberry PI: M2.5 standoff 5mm, 4x - For Raspberry PI: M2.5 screw, around 5mm, 4x - For holding display: M3 screw, 8 mm, 3x - For cover: M2 heat insert, 6x - For cover: M2 screw, 6 to 10 mm, 6x The hole for the M3 screw holding the display needs to be threaded using a M3 tap (or you can use M3 heat insert if you prefer). Note: for the Raspberry PI I didn't have M2.5 insert. I used M3 instead. I had to enlarge the holes of the Raspberry PI board with a 3mm drill. There's plenty to room on the board to do so. Need to print: - frontAssembly.stl, 1x - cover.stl or coverSideOpen.stl, 1x - blocker.stl, 3x No support required. Need a printer with at least 150mm bed. Warning: the customizer doesn't seem to be working well with this model.