Raspberry Pi Camera Cable Clip for TAZ 4/5

thingiverse

I modded my camera mount to hold the flat ribbon cable to the side of the aluminum plate on a Taz 5. This safely holds it away from the plate edges to prevent vibration wear and helps route the cable to the rear of the Taz where I have my Pi mounted. Print flat on the plate with any filament but I would recommend something high temp as its very near be build plate and will need to take some heat. It should hold as is but if your cable rubs against your enclosure, set the part height (Y) to 200% to give it more friction against the build plate and the cable. Shouldn't slid around then.