Raspberry Pi Camera V2 Case and Mount

grabcad

Raspberry Pi Camera V2 Mount for Ender 3 v2 3D printer.Parts are designed to be 3d printed and snap together.Assembly:Install the Raspberry Pi camera onto the mounting plate by pushing the two tabs inward, slightly bowing the part into a U shape. Slide the camera over the pins then release the tabs and the overhang on the pins will grab onto the Pi camera.Install the ribbon cable on the Pi camera (best to do this before it is attached to your Pi, otherwise, feed the cable through the slot in the rear half of the housing first)Push the mounting plate through the back side of the front half of the housing. The two bumps on the mounting plate's tabs should snap into the offset dimples in the front half housing (orientation matters)Feed the ribbon cable through the small slot in the rear housing half (unless already done in step 2) then snap the rear and front housing halves together.Install the ball on the housing bracket into the socket on the arm. This took a bit of force and was easiest for me to put the arm flat on a table then push the housing bracket down into it.Install the housing bracket onto the rear half of the housing. Insert through the large part of the hole then slide to the center.