Raspberry PI RPI4 noctua NF-A4x20 fan case

prusaprinters

<p>Based on the excellent case by Pillar I changed it to suit my SSK External 128GB Portable SSD, USB 3.1 Gen2 (6Gbit/s) SSD External Disk. It needed to be just 1mm taller.</p><p>I ordered a short USB to usb-C cable with angled connector because the regular connector is to long to fit inside the case (maybe diagonal it would fit but no room for storing the cable).</p><p>Just print vent_grid_plus_1mm.stl, pi_support.stl and body_without_ssd_plus_1mm.stl.</p><p>Roll up the cable to fit next to the SSD and have minimal length outside.</p><p>I used &nbsp;M2.5 BHCS 6mm screws for the pi. I first screw them in to create a thread and then add the Pi en screw that in.</p><p>I used M3 screws 4mm on the back.</p><p>Temperature went down from 70 degrees celsius (and cutting out) with just a flat big heatsink to 35-40 degrees celsius.</p>