Raspberry Pi Wall Mount (re-usable/easy access)

thingiverse

This is a sturdy Raspberry Pi wall mount. The support that holds the Raspberry Pi is made from 4 toothpicks. This is because cases that use a printed solution though the mount holes often are too brittle and break. The mount is designed to remove and install the Raspberry Pi dozens of times. ------------------------- Instructions for printing: Only use support for the WallMount base. -support touching build plate should be used. All parts should be printed "flat" on the printing bay. ------------------------- Toothpick instructions: place toothpick on a quarter OR use calipers to measure your cuts (approx 24mm long wood segment) For quarter method, use scissors to cut toothpicks to size. The toothpick segment length should not exceed the diameter of the quarter. For me, glue was not needed on the toothpicks to secure into the base (The top part slips freely). Glue may be needed to secure the toothpicks into the base part. Common wood screws can be used to secure the mount into the wall/surface. Clips should not be over compressed. If you have trouble sliding clips in, slide one leg of the clip in the assembly at a time.