Raspberry Pi Zero Camera Case - longer version

thingiverse

I put it in the storage room on highest place with a motion detection enabled, so the angle is perfect for me. The predecessor's case is a good design for it. > But my raspberry was shutdown more then once probably due to heat. So I added some holes to top part. > As my 3D printer was not correctly calibrated, I had problem with the camera cable being too much under stress/curves. So I had to extend the space between RPi and camera by 1 cm. So, the model is now longer by 1cm (top and bottom). > Had to cut a bit around the usb connector, as none of mine was properly locked there.