Raspberry Pi Zero Case

prusaprinters

<p>This is my Pi Zero Case designed mainly to hold my Pi Zero W , but also works with the normal Pi Zero as well with wifi dongles.</p> <p>Its designed to allow the Pi to just slide in and the power cord keeps it in place. As it uses a sleeve to hold the Pi it also means it is quite robust and doesnt break mounting lugs and also does not neeed screws or bolts to hold it in.</p> <p>In addition, the top can take a Neopixel LED ring for added shazam and a rotary encoder as well if you want to have some input.</p> <p>I've managed as well to fit an I2C audio amp and rectangular speaker inside as well. It all prints easily and the only trick is that i have printed the LED diffuser in PETG with 0% infill.</p> <p>If you just want it as a case, then you can omit the light ring and I will be adding a knob replacement that is a snug fit so that it all fits nicely.</p> <p>Hope you like it and it makes a change from the standard flat rectangles.</p> <p>Also see <a href="https://www.thingiverse.com/thing:2611073">https://www.thingiverse.com/thing:2611073</a> which has a built in OLED display</p> <p>I also have an instructable to use this case and a Pi Zero to control mains sockets via Alexa and emulating RF signal required for the plugs.</p> <p><a href="https://www.instructables.com/id/Alexa-and-Remote-Controlled-Main-Plugs/">https://www.instructables.com/id/Alexa-and-Remote-Controlled-Main-Plugs/</a></p> <p>For those that have asked I have some of these available in etsy<br/> <a href="https://www.etsy.com/uk/listing/677951959/raspberry-pi-zero-case">https://www.etsy.com/uk/listing/677951959/raspberry-pi-zero-case</a></p> <h3>Print instructions</h3><p>Unassociated tags: pi zero case, pi zero w, raspberry pi zero</p> <h3>Category: Computer Print Settings</h3> <p><strong>Printer:</strong> Malyan M200</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Infill:</strong> 20%</p> <p><strong>Notes:</strong></p> <p>It has all been printed in PLA+ at .21875 and 20% infill. The LED diffuser was printed in PETG with 0% infill</p> <p>The sleeve was a remixed/remixed version - of this original sleeve - <a href="https://www.thingiverse.com/thing:1161310">https://www.thingiverse.com/thing:1161310</a></p> <h3> Pre-made option</h3> <p>For those that have asked I have some of these available in etsy</p> <p><a href="https://www.etsy.com/uk/listing/677951959/raspberry-pi-zero-case">https://www.etsy.com/uk/listing/677951959/raspberry-pi-zero-case</a></p>