Raspberry Pi Zero W USB Dongle Case, Modded Header/USB-Pos/Heat-Sink

thingiverse

Instead of gluing my USB-Connector or buying a interface pcb, I just reused an USB-Connector from a old DVB-T-Stick and soldered it right to the ground pads of the unmounted connector. (Quick&Dirty) Because the pads for that unmounted connector are not right in the middle, I had to move the breakthrough for the USB a bit. I liked to have access to I2C, but not to all header-pins and I wanted the possibility to use a heat sink. To do all this I added some parameters and lines to the scad-file. Hope somebody can need it too