Raspberry Pi3 Case for HiFiBerry Amp2

thingiverse

This is a case for a Raspberry Pi 2 & 3. It can house a Hifiberry AMP2 amplifier. All the ports of the Rasberry are open and should be easy to access. I have hidden all the sockets for the amp so you should be able to just insert the wires and screw from the top holes. The front has markings on which wire should go where. The case has standoffs on the bottom and I have made some spacers to hold the AMP2 at the correct distance so that it doesn't flex on GPIO ports. The lid is a clip on lid and should go on fine. All the parts that clip are 0,5/0,6 smaller for 3d printing tolerances except the standoffs as you can easily sand them if needed. I haven't added any grills or fan slots to have a clean case. I have found out that my RPi 2 and 3 work just fine with a heatsink and nothing else. Nothing heats much so I don't think it was needed. Modify this design to your liking but I would be grateful if you'd tip if you can just so that I can show my wife that my tinkering is not worthless (as she said),