RasPi/Octopi Case for Prusa Printers

thingiverse

The original design is good but I don't like the idea of wasting a lot of supports just for the power supply box + Some of the screw holes adjusted to 2.8mm. + Uses 40mm fan with clearance to X axis motor in mind. + Added bunch of grills for better airflow when adding fan. + Fan and GPIO cut out are thin, just cut it out with knife. + Adjusted mounting arm to be flushed as prusa mk3's frame of 50mm to avoid printed parts rubbing on the extruder cable sleeve. + Using https://www.thingiverse.com/thing:4613715 and https://www.thingiverse.com/thing:4614639. + Support arm added to Power box because it has been widened. + Added alignment slot to prevent power box from swiveling as proposed in original design. + Power box are not hanging in the air to eliminate the need of supports when printing it. + Added Chamfer to Micro USB, HDMI, SD card slot. + Redone cut out for 3.5mm Jack that is off based on https://www.thingiverse.com/thing:3908965. + Adjusted IO clearance especially the Female USB sides. + Adjusted to use 10mm or lesser screw for the raspi.