Raspi2 and pidrive case

thingiverse

I wanted a standard housing for my raspi2 paired with my pidrive. Building a box, I added ventilation holes and molded it into the sleek sleeve case that this design is inspired from. To keep the drive in place, I printed two retaining clips. Unfortunately, the fit of these clips, created using PLA filament, feels a bit too loose for comfort - probably better than having them too snug to remove with my printrbot red filament prints. Hopefully, the hard drive will not produce enough heat to melt the plastic. Adding some rubber grips would greatly enhance usability and prevent it from sliding around.