Razer Microphone Boom

thingiverse

Reddit Post: https://www.reddit.com/r/functionalprint/comments/zfc91e/rotational_mic_boom/ A few things to note: 1) This is still a work in progress as the mic usually pulls down due to gravity while in the ball & socket. It works for me once set in a still position. However, even the slightest touch to the mic may cause it to fall. Suggestion would be to ever so slightly scale the Razer_To_Male_Socket stl up just a hair (101/102%). This will cause it to be harder to initially insert into the socket but may keep the mic from falling/angling down so much. 2) Scale the Wall_Mount stl up by 101/102% as the Wall_Mount_Swivel is slightly loose. I prefer it this way as it turns effortlessly but could be ever so slightly tightened. 3) This can be derived to perform for any microphone given an adaptation piece. The piece for this is the ball & socket combination where the ball has a thread connected to it in which screws into my particular microphone (Razer Sieren Mini). If one were to take the thread end, chop off the thread, and add a different adapter to the ball, this could theoretically work for most mics.