RC airplane bracket for keyboard stand - assembly stands - Ver.1

prusaprinters

<p>Version 1</p><p>Support for a RC model airplane with a keyboard stand.</p><p><br>I used an Adam Hall Stands SKS 03 keyboard stand. This is a stable keyboard stand with double square braces and quick adjustment. However, it works with any other identical keyboard stand, which has a tube diameter at the top of 28mm. Otherwise the cross brace, depending on the model must be adjusted.</p><p>The frame is firmly clamped by opening the keyboard stand and cannot slip or fall off.</p><p>The length of the longitudinal struts can be adjusted according to personal needs, since the brackets are continuous and the aluminum profile can be pushed through. So that the aluminum profiles fit correctly, it is best to first print the parts and then measure the appropriate length of the aluminum profiles.</p><p><br>Dimensions of the keyboard stand<br>Tube width: 405mm<br>Tube diameter: 28mm</p><p>3D printed parts:</p><p>Frame<br>2x Corner For Frame Right<br>2x Corner For Frame Left</p><p>Model Holder<br>4x Model Holder Slider<br>2x Aircraft Fuselage Holder For Round Fuselages Small<br>2x Aircraft Fuselage Holder For Round Fuselages Large</p><p>Wing Holder<br>1x Wing Holder 1<br>1x Wing Holder 2<br>1x Wing Holder 20x20mm</p><p>Accessories (All optional)<br>1x Tool Holder Screwdriver<br>4x Belt Holder (to tie the RC model to the frame)<br>4x Hook (to tie the RC model to the frame)<br>8x Endcap 20x20mm<br>1x Tray For Screws<br>1x Tool Holder Pliers<br>1x Transmitter Holder</p><p>2/4x 90 degree angle for frame for optional extension<br>(Only needed if you want to extend the frame for long RC models)</p><p><br>The printing time is 230 minutes per holder (0.4mm nozzle, 1.75mm filament) with a resolution of 0.3mm.</p><p><br>Aluminum profile 20x20L B-type groove 6<br>2x 500mm for the longitudinal struts (length as you like)<br>2x 355mm for the cross braces (depending on the type of stand used)<br>4x 150mm for the model holders (length as required or model)</p><p><br>Minimum screws (as needed)<br>30x M5x10mm<br>30x 5mm washers (optional)<br>4x star grip screw, thread M5x15</p><p>Padding<br>For the glider mount I cut suitable strips of foam rubber and glued them with double sided tape.</p><p>The padding on the 20x20mm aluminum profiles is from the hardware store and a foam expansion profile in gray.<br>Fits perfectly in the 6mm groove and can be easily removed and adjusted again.</p><p>&nbsp;</p>