RC-benchy 3D-printable

grabcad

So i decided to make an RC-Benchy boat. Its printed with 25% infill ABSI printed it on my regular prusa printer and my D-bot. I glued the parts with ABS-slurry (A cup of Acetone and some abs filament for glue) I also used the slurry and applied it to the body to make it waterproof, 2-3 layers.There is one thing i would have done differently then i assembled the motor DO NOT use a glue gun, buy some epoxy-glue instead. I have some small leakage from the motor, so i removed all the glue and used ABS-juice to glue those parts also, but epoxy would have been a better option. I also integrated the support for the servo in the hull.The parts I have been using is these:Rc-controller - https://goo.gl/qMHYCGESC - https://goo.gl/7bu7ouServo - https://goo.gl/igrLKySteel shaft for servo - https://goo.gl/bGjfYvWater proof plastic organ sleeve - https://goo.gl/X2DQ3iLipo battery - https://goo.gl/Sz3hNRLipo battery if not shipping to your country - https://goo.gl/1NdsGFBattery charger - https://goo.gl/ARW9ycJet motor - https://goo.gl/6TM7CJEpoxy-glue - https://goo.gl/wux3mrXT-cable converter https://goo.gl/KfVtNN​3 mm inner diameter sillicone tube - https://goo.gl/1QEdMsTools:3D-printer - https://goo.gl/VTXWFaSolderiron - https://goo.gl/SE2KizSolder helpinghand - https://goo.gl/nwfH0xCutting Plier - https://goo.gl/nwfH0x