RC Boat 2204 motor

thingiverse

Hi, this is the remake of a boat my teacher (J.H.) from primary school made for school competitions. (original was made from wood). In 2019 it was first time used for primary school competitions. (it works great) <font color="red">GENERAL!</font> Size of the boat is 36 cm. To print the boat you will need at least 450 g of red filament and 100 g of black. For the electric hardware it is recommanded to use 2204/2205 brushless motor, at least 40A airplane esc, one 9g servo motor (SG90/MG90). Other parts: You will also need a boat shaft (spare part: Volantex V792-2 Shaft), rudder (Feiluf FT009 rudder), fins (FT012 - rudder fins), Coupler (2.3mm to 5mm) - https://www.banggood.com/Volantex-V792-2-RC-Racing-Boat-Spare-Parts-Rudder-Push-Rod-V792205-p-1039865.html?rmmds=search&cur_warehouse=CN .. - https://www.banggood.com/8PCS-Feilun-FT009-Rc-Boat-Spare-Parts-Tail-Rudder-Kit-Steering-Components-FT009-7-p-1476954.html?rmmds=search&cur_warehouse=CN - https://www.banggood.com/FT012-RC-Racing-Boat-Spare-Parts-Steering-Engine-Unit-FT012-6-p-979089.html?rmmds=detail-bottom-viewalsoview__2&cur_warehouse=CN - https://www.banggood.com/2mm2_3mm3mm3_17mm4mm5mm-Copper-Coupler-For-RC-Boat-p-943629.html?rmmds=myorder <font color="red">INSTRUCTIONS!</font> Printing should be done in two pieces for hull, i printed it with the PLA filament with supports. To print the motor mount you will need some ABS filament (so it will be heatproof). 1. To install the shaft make sure you install it similiar as the photos show, becouse this is probably the most ideal angle and it works great with my boat. 2. install the motor to the mount and attach it to the front hull. 3. glue the front and rear hull together. I used <font color="green">Loctite power flex gel</font>. After i glued all parts together i did paint it with no color varnish, so it is even more solid and more glossy. 4. install the servo (SG90 or MG90), i used hot glue to attach it inside the boat. 5. glue the rudder to the rear end of the boat (Two component epoxy) - please follow the photos (it works great with the setup in my case) https://www.youtube.com/watch?v=4qJE2gZh42k&feature=youtu.be <b>ALL PARTS AVAIBLE: https://cults3d.com/en/3d-model/gadget/rc-hydroboat</b> BOAT WORKS GREAT WITH THIS SETUP!