RC Car Tool Holder

thingiverse

This is a simple to print tool holder for RC thing tools. When printing print four legs vertically. I used a brim of 4mm to insure the legs didn't fall over. For the top and bottom I used a 12mm brim which may have been over kill, as long as you use a hexagonal infill it shouldn't warp. I printed this with some old Raptor PLA, .3mm layer height, 60mm/sec, .4mm nozzle, and heat bed at 65C. You will need 4 counter sunkm3 screws 10mm long, and 4 button head m3 screws 8mm long to assemble.